When setting up the Videon encoder, make sure to check your source video and audio as well as the input settings on the device.
Source Video
- Ensure the source video is turned on and plugged into the Videon device in either the HDMI or SDI in port.
- Check that the output resolution and framerate of your source are supported by the Videon encoder. A list of supported resolutions is found in the Input Specs on the Product Resources page for LiveEdge® Node here, and LiveEdge® Max here.
- Ensure that the input source is not HDCP protected. Sources with HDCP protected content, such as a Blu-ray player or DVD player, will not be able to be encoded.
Source Audio
- Ensure that audio is present either embedded in the HDMI/SDI input or via the 3.5mm audio jack
Input Settings
- Ensure that AV Input Type is set to the corresponding audio/video source plugged into the Videon encoder
- If audio is included in the HDMI/SDI input, select HDMI/SDI with Embedded Audio
- If audio is separate from the video input, select HDMI/SDI with 3.5mm Audio
Linked Article
To see the expected behavior of Videon devices supplied with HDCP-protected source content, check out this article.